Could anyone give me the sys file that can make iGO Primo to load faster? I don't need the system to check the map update; I only need maps and POI's.
I'm using iGO on my Fly Audio 800 x 480 with WinCE 5 (on car). Right now it takes over 1 minute to load. Is there any way to make the starting-up time about 10-15 secs? I don't need the latest version since it takes longer for new software to load on the same hardware. However, I need the latest map.
If so, which version should I use?
If I switch to iGO 8.3.5, will it load faster? What would be the differences between the Primo and 8.3.5 versions?
Last edited by tengiday; 12th January 2014 at 15:19.
That's not an usual behaviour of any iGO software on any winCE device...Primo usually loads in less than 20 seconds even on low-end systems. I believe there must be an issue with your current sys or with primo version itself..Try to delete SAVE folder and use simple sys: