I have Dynavin unit in my car, it runs WinCE 6.0 and iGo Primo 2.0. It works fine, but I've discovered a bug - when I arrive at some location, Primo asks me if I've had arrived. If you click yes, it shows big Exit button (and some others to). If I press Exit button it crashes the whole WinCe, not only app. Is there any way to delete this exit button? I don't need an exit button since Primo is running constantly.
I had the same problem here. I went to a black screen an the bluetooth and navigation wasnt working anymore. I had to disconnect the unit. And removed the breaker in the back. Left it for 10 minutes without power and the whole unit worked again.
Crash is caused with Exit button because it does not quit the program but it sends "sleep" signal to WinCE system. Black screen is basicly your WINce part sleeping and there is no other way to wake it up rather than hard reset (just unplug the device, there is no need to wait 10 minutes).
Some say that you could disable destination arrival menu (so no exit button) is shown by adding this line to sys.txt
I have never had this problem with primo2.0 but i always had it with early versions of primo2.4.
However, i now have primo22.214.171.124.13.405512 and this behaves perectly. I have also the diMkaWA_P174 skin installed, which gives a lot of extra options and also the ability to choose what happens when you reach your destination.
check the license folder ..and check if you have this license, and delete it: PearlAgency PNA DEU@10Q2.lyc if not, delete all licenses and place only a generic one (e.g. Primo_FEU@10Q4_(NQ,_3DL,_ExtPost,_TT...1)_(v2.1)_.lyc ) and no other and check again. The mentioned license generate a crash when Exit.