Go here :
Go here :
One more question...
Does anyone knows how to install IGO on MyWay? I have RNEG with FW R40.03 and new cracked maps 2012/2013 currently, on 16GB SD card.
How to install and which version of IGO I have to find (for android, PC...)?
First time updater of software (27.01) and was a little worried about updating. No need as inserted cd and followed instructions with no issues. Thanks to up- loader as now I am able to see contacts in my phone book and when they ring instead of just junk like before.
Any reason to update if on 20.16?
Do you know of a changelog for every FW until 40 ?
Thank you for your help,
100% Sure Firmwareupdate DS3 or same equiped cars.
-push 1+2+3 buttons simultaneously
-select Softwareversion,read it
rneg_D_R29a_R29.01 (or other same format version)
Prepare FirmwareSDcard 4Gb.
-Check Card on faults
-Download ZIPfile 40.03 from internet.
-Unzip downloaded file DIRECT to prepared FirmwareSDcard.
-Check card on faults.
Perform update in car.
-Do NOT start the car.
-Chane Navigation SDcard with prepared and checked FirmwareSDcard.
-Start car,wait (may last up to one minute while visualisin various changes on screen) for message "Software updat Yes or NO".
-Answer YES by rotating and pushing selection button.
DO NOT TOUCH ANY,REPEAT,ANY BUTTON FROM HERE TO UPDATE FINISH!!!!
-Screen goes dead for seconds.
-Messae appears äfter second: "Busy with update Please wait..." -
-Screen shows update states with percentages.
-After between 15 and 20 minutes message:
Change FirmwareSDcard with Navigation SDcard.
How big is the firmware? how many MB? mine is 54.8 MB ???
2.Screenquality upgrade (number of pixels/points displayed)
CAN BE SEEN!!!
Softwaresytem checks "ready to read".
Software system first checks if Upradenumber is hiher than existing.
Both conditions true it beins conversion with screen-quistion "Yes"or "no".
So you can quit here if you want to.
For instance if you forot the following:
BE SURE YOU CHECKED YOUR CARD OR DVD 100% SURE:
Steps: My Computer-SDcard/DVD+CDfirmwar-Property-Control with repairboxsigned (checktime depends on capacity,is certanly NOT fast).
It only can go wrong at the end of the procedure by reflashing the on-board-read-only-memory.
and this only can happen if due to an uncontrolled medium as described above a bit is read wron!
Then results are unpredictable but usually DISASTROUS!!
A second reason for going wrong as described is electric breadown f.i by switchin off.
If disastrous,Firmware can only be restored by a specialist in electronics or a new Myway-system!!